N54 Tuning Preparation

N54 Tuning Preparation – Maximize Horsepower Gains

The N54 is a very strong production motor that is restricted by the low-boost setting of the stock tune. Due to the n54’s capabilities there are no supporting modifications required despite a tunes ability to increase horsepower and torque by nearly 100 over stock. However, there are a few minor maintenance items that should be addressed before tuning your n54.

 

Spark Plugs and Ignition Coils

Ignition coils send an electric charge to the spark plugs, which in-turn causes the spark plug to create a small spark. This process is what allows the air/fuel mixture to ignite beginning the power stroke of an engine. As with any motor, when you tune your N54, thereby increasing boost and power, you are also increasing the fuel requirement for each burn cycle. When you subject the cylinders to additional fuel then you need a larger spark to ignite the air/fuel mixture. Old, worn-out spark plugs or ignition coils might not create any issues on the stock tune. However, once you increase the demand on your plugs and coils they begin to show their weaknesses. These weak plugs or ignition coils can cause misfires, which may possibly lead to more serious issues down the road.

If you have not replaced your spark plugs in the last 25,000 miles, we highly recommend replacement before tuning your car. The life of ignition coils is longer than plugs, but if these have not been replaced in the last 40,000 miles we also recommend replacement. An important point to bring up is this: regardless of how long it has been since you last changed your spark plugs and ignition coils, replacing these will lead to an increase in engine performance and response. These are relatively inexpensive, yet important maintenance items, so early replacement will never hurt.

 

Walnut Blasting (Intake Valve Cleaning)

Due to the N54’s direct injection (DI), oil blow-by can cause serious carbon build-up on the intake valves. As carbon builds up on the intake valves, it restricts some of the airflow into the engine. This can cause symptoms such as rough idling, slow throttle response, reduced power, and even misfires. Most people recommend cleaning the intake valves (walnut blasting is typically the most effective method) every 50,000 miles. This is not something that needs to be addressed immediately before tuning your n54. However, it is something to keep in mind as extensive carbon build-up may result in reduced power and misfires.

 

Fuel Injectors

As mentioned earlier, when increasing horsepower you are also increasing fueling demands. Some older model N54’s (with the old injector-indexes) have been commonly known to leak and fail. Due to the high cost of replacing fuel injectors it is not recommended that you do this as preventative maintenance. Rather, this is another area to pay attention to after tuning your N54. Leaking or faulty fuel injectors may also lead to a rough idle, loss of power, and engine misfires.

 

Summary 

Spark plugs and ignition coils play an important role in engine performance and have shorter lives on tuned N54’s due to the additional demands from increasing boost and power. These are two important maintenance items that should typically be replaced before tuning your N54. Carbon build-up and fuel injectors are two weaknesses that may be exposed once tuning your car; it is not important to address these issues before tuning unless you know this is already causing issues. To recap on the recommended replacement and maintenance (in order of importance):

1) Spark plugs – 25,000 Miles

2) Ignition Coils – 40,000 Miles

3) Intake Valve Cleaning – Recommended every 50,000 Miles

4) Fuel Injectors – Expensive to replace but due to the common issues it is important to keep an eye on this after tuning

 

 

The following two tabs change content below.

Zach

Latest posts by Zach (see all)

By | 2017-06-07T10:52:41+00:00 June 2nd, 2017|Featured, N54 Maintenance, N54 Tuning Guides|0 Comments

Leave A Comment